View Single Post
Unread 03-11-2013, 07:34 AM   #1
Darklight
Old Timer
 
Darklight's Avatar
 
Join Date: May 2010
Location: Charlotte,NC
Posts: 1,836
Default

After watching a couple videos online, it looks like I should be able to use the ball joint tool to remove these while they're still attached to lca, I would just need to swing away the spindle and cv to get to the top of the lbj and use the bj tool to remove and install in the drive way.

Thought I would add my info on here. I rented ball joint kit part# 648617 PowerBuilt from a local Advancd Auto Parts and was able to remove the stock weeping/worn lbj and press in the Moog lbg. Remove the 2 lower 19mm bolts 103 lbs trq, then remove the 1 large bolt holding the lbj on is a 24mm bolt 166 lbs of trq . Remove the tierod from the spindle 19mm bolt 67lbs of trq. Jack up, support and push to the side the spindle assembly/cv. The kit comes with multiple pieces for removal and installation. You will need a 22mm socket to use the kit. You have to watch the video to get a better idea of the configuration for removal/installing. If you like puzzles you can figure it out pretty easy,lol. Once you have the configuration of the tool on properly it takes some muscle. It was a bear to press it off. I used a 1/2" breaker bar with a 2' cheater pipe and rowed it gradually off. Same thing for install just reverse. I didn't have to remove LCA to get to it I just used a floor jack to push the spindle and cv assembly up and off to the side far enough to get to the lbj. I moved them towards the firewall/vehicle. Also, I used the caliper as the jacking point and had several bungy cords supporting the spindle as well. On the top of the stock lbj is a large c-clip/snapring. I used a flathead scredriver and a hammer to tap it off. Watch it when it comes off it will go flying I will get some pic's up of the install as well.

Overal I am very happy with the results for $30.00 Moog lbg from Amazon and a $0 rental tool I was nervous going in to this but it was not that bad really. I was quoted from $150 - $1,300.00 from 3 shops to either remove the lbj or replace the entire lca assembly. Only 1 shop said they would do just the lbj and that was a fello friends shop that knows Toyota's and works on this platform.

Here is the videos I watched before hand.


http://www.ehow.com/video_4401498_pr...all-joint.html


http://www.ehow.com/video_4401499_in...all-joint.html
__________________
2008 Black 4X4Runner SR5 V6, Total Chaos Race series 2" plus kit, King 700 lbs LT coilovers & MetalTech stage 5 LT rear, 315/75R16 KM2, Strike 6 16x8.5 -6 wheels , Demello offroad 3 hoop, 4X4Labs rear, ATO, RCI ,BudBuilt, Stubbs sliders, 4Crawler B/L 3/4", DynoMax , K&N , Speski barrier, sPOD, ARB CKM12, ARB locker front/rear 4.56 gears WMW roof rack
Darklight's Build
Darklight is offline